Mittler-bros-machine-tool QM Kart Chassis Dyno Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour l'eau Mittler-bros-machine-tool QM Kart Chassis Dyno. Mittler Bros Machine & Tool QM Kart Chassis Dyno User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Chassis Dyno Instructions
1. Lay the dyno frame out on the floor.
2. Level the unit using the leveling feet.
3. Remove the vent plug from the top of the dyno.
4. Fill the frame of the dyno with 4 gallons of ATF (automatic transmission fluid)
5. Re-install the vent plug.
6. Insert control panel into the dyno frame (right rear corner).
7. Loosen the pump hose fitting and spin the drive roller by hand to prime the pump.
8. Once the pump is primed re-tighten the fitting.
9. Plug the hoses from the control panel into the dyno frame.
10. Place the drive tires of your vehicle on the dyno rollers (it may be necessary to
space the front of the vehicle off the ground to keep it from touching the dyno
frame).
11. Strap the vehicle to the dyno front and back to prevent the vehicle from moving or
coming off during testing.
12. Hook up the throttle linkage from the control panel to the engine of the vehicle.
13. Open the load valve on the control panel all the way up (counter clockwise) and
then turn it ½ a turn clockwise.
14. Start the vehicle and warm the engine up.
15. Using the throttle lever, increase the engine RPM and turn the load valve
clockwise until the engine RPM starts to decrease. You want the throttle at the
wide-open position and regulate the engine RPM with the load valve.
16. When the desired RPM is achieved take a pressure reading.
17. Your goal is to achieve the maximum amount of PSI at a given RPM and load by
tuning the engine.
18. Pull the throttle lever back and shut off the engine. It is not necessary to change
the load valve settings.
19. Plug the information into the formula’s provided.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Chassis Dyno Instructions

Chassis Dyno Instructions 1. Lay the dyno frame out on the floor. 2. Level the unit using the leveling feet. 3. Remove the vent plug from the to

Page 2 - Formula’s:

HP = Horsepower T = Torque PSI = LBS per square inch GPM = Gallons per minute ERPM = Engine RPM Formula’s: HP = (PSI x GPM) / 1714 T = (HP x 5252

Commentaires sur ces manuels

Pas de commentaire